IGM Professional Tools FK650 Mode D'emploi page 2

Operating instructions EN
TABLE OF CONTENTS
Use of jig FK650
Assembling of FK
Cutting of 90° joints
Cutting of 45° joint
Security
Use of jig FK650 / FK651
The jig FK650 is designed for cutting perfect 90° joints (fig. 2) and 45° joints (fig. 3.) for kitchen postform
worktops with the help of portable router.
It extends the possibilities of the router and increases the quality of the machined surface as well as the
precision of the joint. The basis of the entire system is a jig made of resistant plastic and a stop set. Precise
worktop joints, grooves for metal clamps and finishing of corners by radius or 45° can be manufactured by
presetting of respective stops. The complete production of the joint takes approximately 15 – 20 minutes
according to the operator's skill.
2
FK650 is designed for work with grooving router bits with D 12 cutting diameter
FK651 is designed for work with grooving router bit with D 12,7 ( ½") cutting diameter
Hereafter referred to as FK ...
Basic accessories
1 pc Jig made of rigid laminated phenolic with letters indicating the positions of the stops
3 pc Metal stops
1 pc Plastic sliding stop
1 pc Nut with plastic rosette for sliding stop
1 pc Bolt for sliding stop
1 pc Washer
1 pc Operating instructions
Accessories required for the work with the jig:
PORTABLE ROUTER with superior performance (we recommend CMT portable router from our offer)
GUIDE BUSH with dia. 30 mm
If it is not possible to get the guide bush with dia. 30 mm for your router it is possible to buy:
FRB170___
reduction base for mounting of IGM guide bushes for shank S = 8 / 12 mm
FRB171___
reduction base for mounting of IGM guide bushes for shank S = 1/4" and 1/2"
FGB30001___
guide bush IGM with dia. 30 mm for FRB170 and FRB171
FOR FK650 .....STRAIGHT BIT D = 12 mm
F47-12381__
D12,7x30(40) router bit S=8 mm
F47-12521__
D12,7x50 router bit S=12 mm
METAL TIGHTENING CLAMPS for tightening of lamella glued desktop joints
Code FK659 _____
metal screw clamps package of 10pcs
2
3
FOR FK651 .....STRAIGHT BIT D = ½" (12,7 mm)
F47-12371__
D12,7x30(40) router bit S=12,7 mm
F47-12571__
D12,7 x 50 router bit S=12,7 mm
PAGE
2
3
3
6
8
www.igmtools.com