IGM Professional Tools FK650 Mode D'emploi page 6

Operating instructions EN
Insert two steel stops into the B holes from the facing side of FK. Tighten the sliding length stop to the facing
side of the FK and place the jig onto worktop M1 (which is rotated upwards by its underside) by the facing
side. Leave the length stop loose, do not tighten. Set the far edge of jig FK (see arrows) precisely according
to the plotted compensation line on the edge of the worktop by the sliding stop. Set the sliding stop by the
point obliquely onto the compensation line and tighten (fig. 12).
Remove the stops from the B holes. The edge of the sliding stop is a reference point of rotation for the
compensation. Shift using the worktop around the point of the sliding stop so as to adjust the edge of the jig
to the compensatory line according to (fig. 13).
13
12
1
Tighten the jig to the kitchen worktop using the clamps and check that the clamps do not hinder the
movement of the router and that the jig is well tightened to the kitchen worktop. Loosen and remove the
sliding length stop to prevent its damage. Set the cutting depth on the router. Insert the router and begin to
cut the joint on multiple-pass from left to right. Copy the far edge of jig FK (fig. 12).
Cutting of 45° joint
The work procedure is demonstrated on a left-handed 45° joint (fig. 14 and 15). Prepare worktop F2 by cutting
with the circular saw according to the required dimensions, cut as precise as possible. The working procedure is almost
identical as for shaping connections to 90°.
14
15
16
Cutting of inner 45° joint
Insert two metal stops into the C holes and one into the G hole from the facing side of FK. Place FK on kitchen
worktop F2 according to (fig. 16).
Ensure that all stops 1, 2 and 3 are touching the edge of the worktop. Now tighten FK to the kitchen worktop
and working table using the clamps and check that the clamps do not hinder the movement of the router
in the jig groove and that they are well tightened. Set the cutting depth on the router. Insert the router and
begin to cut the joint on multiple pass from left to right, copying the far edge of the jig; see arrows on (fig. 16).
WARNING !!!
While shaping, press the router with the guide bush firmly against the jig and cut from left to right. Always
keep the router perpendicular so that the base of the router is touching FK with its entire surface, and the
guide bush thus precisely copies the shape of the joint on the jig. It is better to cut on multiple pass. For the
rough cutting you can use the opposite edge of the jig groove. Always follow the safety instructions for
working with the portable router and router bits!
www.igmtools.com
6