Attaching The Belt Clip; Switching The Handset On And Off - Siemens Gigaset Comfort 4000i Mode D'emploi

See the appendix for a list of recommended batteries.
G
Once the initial charging process is completed you
can replace your handset in the base station/
charging unit after each call. Charging is controlled
electronically. This ensures optimum charging and
prolongs battery life.
G The batteries heat up during charging. This is nor-
mal and not dangerous.
G Opening the battery compartment unnecessarily
may cause the wrong charging status to be dis-
played.

Attaching the belt clip

Push the belt clip onto the back of the handset until
the lugs at the side click into place.

Switching the handset on and off

a
The handset is switched on as soon as you insert the
batteries and place the handset in the base station/
charging unit.
The default display language on your handset is
Italian. To set the desired language, see page 9.
To switch the handset on and off,
hold down the end call key until
you hear a confirmation beep (ris-
ing tone sequence).
7