Connection For Adjustment Of The Camera - JVC TK-C205 Mode D'emploi

Installation and connection
Mounting the Camera to the Ceiling (Continued)
9.
BNC connector
Mounting
holes
10.
Shooting
direction
11.

Connection for Adjustment of the Camera

Temporarily used for making various adjustments
while the camera remains in the installed location.
IRIS
LEVEL Volume
* The power to the camera body must be ON when adjustments are performed.
E-12
Power supply
cable
Roll with tape
4 inch square
electrical box
M o u n t -
ing
holes
Screws
FOCUS ADJ.
OFF ON
OFF ON-AGC
OFF ON-BLC
AUTO MANU
LL INT
PHASE WHT.BAL.
R B
RESET
SPOT
CORRECTION
FOR
L H
SERVICE
IRIS
LEVEL
MONITOR
9.
Roll cables with insulation tape.
As shown in the diagram to the left, roll
the entire connecting section of the
power supply cable and BNC connec-
tor with insulation tape and insert them
in the electrical box.
MEMO
Rolling cables with insulation tape not only
increases the work efficiency later on, but
reduces the entry of noise, etc.
10 .
Adjust the unit in the direction to shoot.
11 .
When using an electrical box, use the
2 mounting holes to fix the box to the
unit.
CAUTION:
• Do not hold the lens part when mounting
the unit to the ceiling or wall.
• When directly mounting the unit to the
ceiling or wall, fix the unit using all 4
mounting holes.
• Use M4 screws or bolts for attaching the
ceiling mount.
• If wood screws are used, use screws
with a diameter of 4.1 mm.
Setting switch
Adjustment
button
75Ω termination
disconnected
Monitor TV