About Connection Cables - JVC TK-C205 Mode D'emploi

Installation and connection

About Connection Cables

• Turn OFF the power supply to all components before making connections.
CAUTION:
• If thin cables are used (i.e. with a high
resistance), a significant voltage drop
will occur when the unit is at its
maximum power consumption. Either
use a thick cable to restrict the voltage
drop at the camera side to below 10%,
or place the power supply near to the
camera. If voltage drop occurs during
operation, the performance will be
unstable.
• Attach the cable conductors so that they
do not come into contact with the drop
prevention wires.
E-10
Video signal cables
Connect the coaxial cables (BNC) to the video
signal output connector (BNC).
Use the 3C-2V or 5C-2V video signal
cable (coaxial cable). The 7C-2V cannot
be used.
DC 12 V or AC 24 V power supply cable
Connect the DC 12 V or the AC 24 V power
supply to the DC 12V/AC 24V terminals on
the terminal board. To prevent connection
errors or a cable disconnection, we recom-
mend the use of lug plates for the connec-
tions.
To Video
Signal Cable
The following table shows the connection dis-
To DC 12 V or tances and connection cables provided that
AC 24 V
2-conductor VVF cables (vinyl-insulated vi-
Power Supply
nyl sheath cables) are used.
Maximum extension
(reference)
Conductor
diameter
• Do not allow input from both a DC 12 V
and AC 24 V power supply at the same
time.
• When using a DC 12 V power supply,
ensure that the polarities of the cable
are correct.
• The AC 24 V power supply should
conform to the following:
U-type:
E-type:
Note
100 m
1.0 mm 1.6
ø
and more and more and more and more
Class 2 only
Isolated power supply only
260 m 410 m 500 m
mm 2.0 mm 2.6 mm
ø ø ø