Names And Operations Of Parts Camera Body; Body Underside - JVC TK-C205 Mode D'emploi

Names and Operations of Parts
Camera Body (continued)

Body Underside

3
4
1 Power input cable
To input DC 12 V or AC 24 V power.
The AC 24 V power supply should
conform to the following:
U-type: class 2 only
E-type: Isolated power supply only
Video signal output connector (BNC)
2
This BNC connector outputs a composite
video signal. Connect this to the video
input connector of a video monitor,
switcher, etc.
3 Drop prevention wire
This wire is mounted to the ceiling slab
or channel.
CAUTION
Be sure to attach the drop prevention wire.
If not attached, the camera body could
drop down.
E-8
2
1
6
7
4
Main unit side
5
4 Mounting holes
These holes are used to mount the
camera body to the ceiling. When using
a 4 inch square electrical box, the 2
holes diagonally across are used to fix
the box in place.
( page 12)
Cable extraction hole
5
This hole is used when extracting cables
without opening a hole in the ceiling.
6 Cover
This cover is removed when using the
cable extraction hole.
5
7 Cover locking screw
This screw is removed when removing
the cover.
6