Publicité
Les langues disponibles
Les langues disponibles
REMOTE CONTROL
HOW TO INSTALL BATTERIES
1. Open the battery box on the back of remote control, and install
One button battery (CR2032 3V).
2. Put the batteries inside the slot, with anode and cathode in right
directions.
3. Put on the back cover.
Notice:
1. The anode and cathode of the batteries must be corresponding to
the signs of "+" and "-" on the remote controller.
2. For long time no use, take out the battery.
3. To prevent environmental pollution, take out the used battery and
dispose safety and appropriately.
How to Use
To operate the air fan, aim the Remote controller at the signal
receptor. The remote controller at distance of up to 5m when
pointing at signal receptor of the air fan
Slide the cover to open
Be sure the direction is correct.
CLEAN & MAINTAINANCE
If there is too much dust or dirt on the front grid cover and wind
wheel of the fan, the performance of air-out would be affected, so
we suggest clean the fan once per month at least.
1. Always remember unplug the fan before cleaning, or may cause
electric shock or product damage.
2. Clean with Ordinary cleaner and banister brush. Do not use any
Chemical agents.
Unit surface cleaning
1. Do not allow water and steam to drip on.
2. Do not use corrosive detergent or solvent cleaning.
3. Always unplug the fan before cleaning.
Maintain guidance
1. Unplugged and packed to prevent dust from entering the body if
not use for a long time.
2. Placed in a dry well ventilated place after packed.
TECHNICAL SPECIFICATIONS
Model
Power
Rated Voltage(V/Hz)
Speed
Weight
64
65
DF-AT0900F
45W
220-240V~50/60 Hz
3
4.6kg
Publicité
