Installation; Countertop Installation - Hatco TMS Série Manuel D'installation Et D'utilisation

INSTALLATION

General
WARNING
ELECTRIC SHOCk HAzARD:
• Unit must be installed by a qualified electrician.
Installation must conform to all local electrical codes.
Installation by unqualified personnel will void unit
warranty and may lead to electric shock or burn, as well
as damage to unit and/or its surroundings.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 21°C (70°F)
and a maximum of 29°C (85°F).
FIRE HAzARD:
• Install unit on and around non-combustible surfaces
with non-combustible construction only. Ensure
surface construction has no combustible material
against underside. In all cases, such construction
shall extend at least 305 mm (12") beyond equipment
on all sides.
• Locate unit a minimum of 51 mm (2") from any walls. If
safe distances are not maintained, discoloration or
combustion could occur.
• Do not obstruct air intake openings or air exhaust
openings on outer housing of unit. Unit combustion or
malfunction may occur.
• Do not place anything on top of unit.
For wall mounting, use special wall mount bracket
provided with unit only. Secure wall mount bracket to a
solid, non-combustible surface using appropriate hardware
for mounting surface and weight of unit.
Locate unit at proper counter height in an area that is
convenient for use. Location should be level to prevent unit
or its contents from falling accidentally and strong enough
to support the weight of the unit and contents.
Do not place anything on top of unit; doing so may subject
personnel to injury or damage unit.
NOTE: A qualified person must check possible placements of
the salamander to ensure that the proper electrical
supply line is available.
NOTE: To prevent delay in obtaining warranty coverage,
complete online
NOTICE Use non-abrasive cleaners and cloths
only.
CAUTION
warranty registration.
section for details.

Countertop Installation

See the
Transport Locking
Screw
Countertop
51 mm (2")