Publicité
3.
Install the U-Channel
U-Channel
Profilé en U
Canal en U
Hollow Seal
Joint creux
Sello hueco
NOTE: Apply petroleum jelly to the hollow seal if needed to help it slide easier.
On the pivot side of the bottom track, pull the hollow seal 5" (12.7 cm) beyond the
edge of the bottom track.
Slide the hollow seal through the base of the U-Channel until it is 1" (2.5 cm)
beyond the other end.
Slide the U-channel onto the pivot end of the bottom track.
Adjust the U-channel so the end is 1" (2.5 cm) from the pivot end of the bottom
track.
Trim the excess hollow seal off each end of the bottom track.
Sterling
Bottom Track
Rail inférieur
Carril inferior
5" (12.7 cm)
Hollow Seal
Joint creux
Sello hueco
1" (2.5 cm)
7
1063213-2-B
Publicité
