AEG S60360KG1 Manuel D'utilisation page 14

14
What to do if...
Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
Water flows on the
ground.
There is too much frost
and ice.
The temperature in the
appliance is too high.
The temperature in the
refrigeration is too high.
The temperature in the
freezer is too high.
The appliance does not
operate.
The lamp does not work.
As much as the advice does not lead to result, call the nearest brand-mark service.
Possible cause
The FROSTMATIC function is
switched on.
The COOLMATIC function is
switched on.
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
Products are not wrapped prop-
erly.
The door is not closed correctly. Refer to "Closing the door".
The Temperature regulator may
be set incorrectly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket.
The lamp is in stand-by.
The lamp is defective.
Solution
Refer to "FROSTMATIC function".
Refer to "COOLMATIC function".
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Wrap the products better.
Set a higher temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".