Handle Settings - Husqvarna HTC 270 EG Manuel De L'opérateur

Usage
4.2

Handle settings

The picture below shows the handle positions on the machine.
Figure 4-1. Handle settings
1. Forward position - used during transport, since the machine then takes
significantly less room, and as the working position for handling the machine
during grinding where a better view and precision are required.
2. Vertical position - used for tipping the machine, to make changing the tools
easier.
3. Rear position - the working height can be adjusted to one of two positions using
the machine's adjustable handle.
• Lock the handle in the required position using the locking mechanism located on
the underneath of the handle cover, see position 3 in Figure 3-2, page 10.
14
HTC 270 EG
2.0