Lenze L-force 9400 Instructions De Montage page 64

Overview
Pos. Description
MXI1 Module receptacle for extension 1, e.g. communication
MXI2 Module receptacle for extension 2, e.g. communication
MMI Module receptacle for memory modules
MSI Module receptacle for safety equipment
X1 System bus (CAN), under the cover
X2 24-V supply / Statebus
X3 Analog inputs / analog outputs
X4 Digital outputs
X5 Digital inputs
X6 Diagnostics (with diagnostic adapter or keypad)
X7 Resolver
X8 Encoder
Lower cap

Nameplate, retractable

Upper cap

EMC wire clamp

X100 Mains / DC-bus voltage
X105 Motor / external brake resistor
X106 Motor temperature monitoring (position depends on the device size)
X107 Control of motor holding brake
EMC shield clamp

Holes for transport and assembly guides

Shield connection/strain relief (device sizes: 8S, 8 and 9)

Barrier between mains input and other power terminals (device sizes: 8S, 8

and 9)
Switch for operation in IT systems

The LED display enables fast indication of several operating states.
LED Labelling
CAN-RUN
CAN-ERR
DRIVE READY
DRIVE ERROR
24 V
USER
SSP94LED01
Pos. Symbol




© 2007 Lenze Drive Systems GmbH, Hans-Lenze-Straße 1, D-31855 Aerzen
No part of this documentation may be reproduced or made accessible to third parties without written consent by Lenze Drive
Systems GmbH.
All information given in this documentation has been selected carefully and complies with the hardware and software described.
Nevertheless, discrepancies cannot be ruled out. We do not take any responsibility or liability for any damage that may occur.
Necessary corrections will be included in subsequent editions.
64
Colour Description
green CAN bus o.k.
red CAN bus error
green Standard device is ready for operation
red Error in the standard device or due to the application
green 24-V supply voltage o.k.
yellow Message parameterised by the application
Description
Long discharge time: All power terminals carry hazardous voltages for at
least 20 minutes after mains disconnection!
High discharge current: Fixed installation and PE connection to EN 61800-5-1
required!
Electrostatic sensitive devices: Before working on the device, the personnel
must remove any electrostatic charges using suitable measures!

Design
HighLine
2/2
4
8
Optional
Optional
2
4
Inoperable when "StateLine" design is
used
EDK94SH366 DE/EN/FR/ES/IT 3.1
StateLine
1/0
1
4
2
4