Prepare Window For Installation; Position Air Conditioner - Haier ESA415J Guide D'utilisation Et D'entretien

NOTE: Cover putty knife blade with masking tape to guard
against damage of the unit finish.
CAUTION:
Never expose plastic front or grille to extreme temperatures.
Assemble Curtain/Top channel
NOTE: Attach curtains to the air conditioner before placing the air
conditioner in window.
1. Install top channel with four 13/32" screws.
2. Slide left-hand curtain assembly into left end of top and bottom
channels. Repeat for right-hand curtain assembly.
3. Fasten curtain retainer strips to the sides of the outer case with
eight 13/32" screws..
A
B
A. Top channel
B. 13/32" screws
6
C
D
C. 13/32" screws
D. Side curtains

Prepare Window for Installation

1. Measure the width of the window opening.
2. Mark the center line on the inside windowsill.
A
B
A. Width of window opening
B. Center line

Position Air Conditioner

NOTES:
Handle the air conditioner gently.
Be sure your air conditioner does not fall out of the opening
during installation or removal.
The place where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded outlet.
Do not block the louvers in the front panel.
Do not block the louvers on the outside of the air conditioner.
A
A. Side curtain against window channel
B. Window sash behind top channel
C. Bottom channel in behind windowsill
NOTE: Your model may differ from the one shown.
B
C