Basic System Connection - Sony DXC-LS1P Instructions D'utilisation

Basic System Connection

To supply power to the unit, use the CMA-D2CE camera
adaptor (not supplied).
There are two connection methods as follows.
• Using a CCDC cable which only supplies power to the
unit.
For connection, see "Connecting to Video Equipment with
Composite Video Input Connectors" on page 13.
• Using a CCMC cable which supplies power to the camera
and transmits video signals to the camera adaptor.
For connection, see "Connecting to Video Equipment With
Composite Video Input Connectors" on page 14.
12
Note on use of camera adaptors
Be sure to use one camera adaptor for each DXC-LS1P unit.
Although the CMA-D2CE camera adaptor has two
CAMERA connectors (4-pin and 12-pin), the power
consumption of the DXC-LS1P is such that two camera
units cannot be connected at the same time.
Notes on connections
• Be sure to turn off the power supply for all equipment
before making any connections. If you connect/disconnect
the camera cable with the power on, the camera may be
damaged.
• Use proper connecting cables that match the connectors.
• Connect the plugs firmly. When disconnecting the
connecting cable, pull it out by the plug. Never pull the
cable itself.
• As this camera control unit is already adjusted to obtain the
optimum picture using the supplied camera head unit, be
sure to always use these two units together to ensure high-
quality pictures.