Using The C-Mount Adaptor - Sony DXC-LS1P Instructions D'utilisation

Using the C-mount Adaptor

By using the LO-UCMT C-mount adaptor (not supplied),
you can mount any C-mount lens.
1
Screw the C-mount adaptor into the C-mount lens. The
C-mount lens must not project more than 5.5 mm. See
the illustration below.
5.5 mm or less
2
Turn the focus lock ring of the camera head unit
backward as far as it will go.
3
Screw the camera head (the camera cable has not been
connected yet) slowly about 5 mm into the LO-UCMT.
4
Connect the camera cable to the camera head.
5
While checking the picture on the monitor screen, turn
the LO-UCMT forward until the picture is in focus.
36
6
Tighten the focus lock ring to lock the LO-UCMT.
7
Lock the C-mount lens with the white mark of the
camera head unit facing up.
Notes
• When mounting the camera with C-mount lens, lock the C-
Lens mount
mount lens, not the camera head, so that the camera head is
not overloaded.
• Using the C-mount adaptor where the unit is subject to
vibration and shock may cause a damage or looseness.