Basic System Connection - Sony DXC-9100P Mode D'emploi

Basic System Connection

To supply power to the unit, use the CMA-D2CE/D2MDCE
camera adaptor (not supplied).
There are two connections methods as follows.
• Using a CCDC cable which only supplies power to the
unit.
• Using a CCMC cable which supplies power to the camera
and transmits video signals to the camera adaptor.
Note on use of camera adaptors
Be sure to use one camera adaptor for each DXC-9100P
unit.
Although the CMA-D2CE/D2MDCE camera adaptor has
two CAMERA connectors (4-pin and 12-pin), the power
consumption of the DXC-9100P is such that two camera
units cannot be connected at the same time.
Note on connections
Be sure to turn off power supply for all equipment before
making any connections.
Note when outputting the WEN signal to peripheral equipment
from the camera
Before attempting to connect the RGB/SYNC connector
from which the WEN signal is output to peripheral
equipment, make sure to complete all of menu settings
including the D-SUB Sync setting on PAGE 3 menu.
For details of menu settings, see "Adjustment and Setting with
Menus" on page 11.
41