Sony DXC-9100P Mode D'emploi page 16

Adjusting and Setting with Menus
SHUTTER
The electronic shutter allows for blur-free images of fast-
moving subjects and produces good still images of subjects
shot in poor lighting conditions.
Selection Function
OFF
Deactivates the electronic shutter.
STEP Sets the shutter speed to any of 9 steps in high-speed
shutter mode and 15 steps in long-exposure mode.
High-speed mode: 1/50, FL (flickerless), 1/125,
1/250, 1/500, 1/1000, 1/2000, 1/4000 and 1/10000
seconds
Long-exposure mode: 0.1, 0.2, 0.3, 0.5, 1.0, 1.5,
2.0, 2.5, 3.0, 3.5, 4.0, 5.0, 6.0, 7.0 and 8.0 sec.
To set the shutter speed
1
Display 1/50 (factory-set value) by pressing the
DATA UP and DATA DOWN button together.
2
Select the desired shutter speed by pressing the
DATA UP or DOWN button.
On pressing the UP button: The shutter speed
changes in the order 1/50, FL (flickerless),
1/125,1/250, 1/500, 1/1000, 1/2000, 1/4000 and
1/10000 each time you press the UP button.
On pressing the DOWN button: The shutter
speed changes in the order 0.1, 0.2, 0.3, 0.5, 1.0,
1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 5.0, 6.0, 7.0 and 8.0
sec.
When using the unit with 60 Hz lighting, setting the
shutter to FL gives you flickerless images even under
fluorescent light.
16
Selection Function
VARIABLE Use for fine adjustment of the video output level.
You can adjust the shutter speed in long exposure
mode or clear scan mode.
In long exposure mode
You can set the shutter speed in units of 1 frame.
For example, if the value is set to 50 frames (about
2.0 seconds in the PAL format), the total video signal
produced during this set time is output in the form of
one complete frame at intervals of about 2.0 seconds.
These pictures, which contain 50 frames of video
information, are much brighter than normal one-frame
images. This mode of setting the shutter speed is very
useful for shooting a poorly illuminated subject in a
dark place.
1
Display 312/625 (factory-set value) by pressing the
DATA UP and DATA DOWN button together.
2
Select the desired shutter speed by pressing the
DATA DOWN button.
Each time you press the DATA DOWN button, the
shutter speed changes in units of 1 frame from 1
FRM through 255 FRM.
Shutter speed calculation
Example: Shutter speed when the unit is set at 5
frames
5 × 1/25 = 0.20 seconds
Note
In long exposure mode, AUTO IRIS cannot be used.