Sony IPELA SNC-RZ50N Manuel D'installation page 56

9
Temporarily attach the cable cover by
inserting the raised protrusions on the
cable cover into the gaps at the rear of
the upper ceiling cover. Then fix the
cable cover using the supplied two
M3 × 6).
screws ( 3
Ceiling
Note
Take proper steps to ensure that the load
of the connected cables does not cause
problems.
18
GB
Installing the Camera
Removing the camera
1
2
3
×
3
M3 6
(supplied)
4
5
Remove two screws used to attach the
cable cover in step 9 of "Installation"
and remove the cable cover.
Disconnect the cables from the
connectors at the rear of the camera.
Remove the mounting bracket cover
that is attached in step 6 of
"Installation".
First take off the tab on the edge as in the
illustration.
Tab
Remove three screws used to attach
the camera in step 5 of "Installation."
Pushing the entire camera up towards
the ceiling, turn the camera
counterclockwise as far as it goes,
then pull it out.