KRESS 1400 HKS Mode D'emploi page 22

36727_a_BA_Handkreissäge_1400HKS.book Seite 22 Donnerstag, 20. Oktober 2011 9:25 09
22 English
6. Maintenance and Service
Maintenance and Cleaning
EN
Before carrying out any work on the
machine, pull the mains plug.
Keep the saw and the ventilation slots clean
at all times.
Plastic parts accessible from the outside
should be wiped clean regularly using a cloth
without cleaning agents.
Keep the tool holding fixture clean at all times.
The swing guard must be able to move freely
and close automatically at all times. To
ensure this, keep the area around the swing
guard clean at all times. Remove dust and
shavings using compressed air or a brush.
Non-coated saw blades can be protected
against the formation of corrosion by applying
a thin coat of acid-free oil. Remove this oil
before sawing, as it will mark wood. Resin or
glue residues on the saw blade impair the
quality of the cut. To remove these, always
clean saw blades immediately after use.
Brush replacement
Have worn brushes replaced by an authorised
customer service.
Service
After heavy use over a long period,
the machine should be taken to a
Kress service centre for inspection
and thorough cleaning.
The relevant service centres are listed in the
enclosed appendix "SERVICE" or on the website
www.kress-elektrik.de.
Spare parts / exploded view
Exploded views and spare parts lists are available
on our home-page
http://spareparts.kress-elektrik.de
1400HKS,1400DS-EN / 1106
Maintenance and Service
Environmental Protection
Recycle raw materials instead of dis-
posing of them as waste. The machine,
accessories and packaging should
be sorted for environmentally-friendly
recycling.
The plastic components are labelled
for categorised recycling.
Only for EC countries.
Do not dispose of power tools together
with household waste!
In observance of the European Directive 2002/96/
EC for waste electrical and electronic equipment
and its implementation in accordance with national
law, power tools that have reached the end of their
service life must be collected separately and
returned to an environmentally compatible recycling
facility.
Warranty
1. This power tool has been carefully tested and has
been subjected to a strict quality control process.
2. We guarantee to repair free of charge such faults in
the power tool as arise within 24 months from the
date of purchase at the end user's premises and
which can be attributed to a material or manufacturing
defect. In certain countries there are special regulations
concerning the warranty terms. We reserve the right
to repair faulty components or to replace them.
Replaced items become our property.
3. Inappropriate use or handling and opening up the
device by unauthorised repair centres renders the
warranty void. The following are excluded from the
warranty: mechanical damage due to falls etc., damage
caused by the ingress of water or other fluids, cut and
damaged cables, motor damage and mechanical
damage caused by inappropriate overloading, wear
parts e.g. carbon brushes, drill chucks, chuck keys,
worn drilling spindles, motors, mains cables, batteries,
saw blades, grinding discs, dust bags, accessories in
general (drill bits, chisels etc.). Details of the various
wear parts can be found at http://spareparts.kress-
elektrik.de or obtained from one of our service centres.
4. The warranty may only be enforced when defects are
reported without undue delay (including shipping
damage). Warranty implementation does not extend
the warranty period.
5. If you need to make a claim under warranty, send the
original purchase receipt together with the device to
us or to the relevant service centre.
6. The warranty obligations assumed by us exclude any
further claims on the part of the buyer, in particular
the right to cancellation of a sale, reduction and the
assertion of claims for damages.