Cleaning; Removing Paint From The Roller - Homeright C800804 Mode D'emploi

REMOVING PAINT FROM
THE ROLLER
Cleaning Instructions for
latex paint or stains.
8
8. Remove the roller cover from
the frame.
12
12. Remove outer end cap from
roller cover by inserting the
frame inside the roller cover at
a slightly cocked angle. Then
gently push to snap off the
outer end cap with the frame.
C820429A_MAN_Pro Electric.indd 8

Cleaning

1-2
1. Place roller into the roller
holder.
2. Plug the unit into 3-blade
grounded plug receptacle.
9
9. DO NOT REMOVE INNER OR
OUTER END CAPS WITH A
SCREWDRIVER! DAMAGE TO
THE END CAPS CAN OCCUR.
13-14
13. Clean roller pieces using warm soapy water or appropriate solvent.
When inner and outer end caps are clean and dry, lubricate o-rings
with petroleum jelly.
14. Clean off any remaining paint from roller holder and other parts.
DO NOT place paint base unit in water. With unit unplugged, finish
cleaning with a wet cloth. NEVER immerse unit in water or solvent.
PRO ELECTRIC PAINT ROLLER (C800804)
3-4
PAINT SAVER FEATURE
3. Depress the paint/clean switch
to the clean setting. Depress the
button on the handle. Allow the
unit to run for 1-2 minutes.
• NOTE: This will return the paint
back into the paint can.
4. Depress the button on the
handle to turn the unit off and
unplug the unit.
• NOTE: When removing roller
from roller keeper, roller cover
could be saturated with paint.
10
10. Remove inner end cap from
roller cover by inserting the
frame at an angle into the inner
end cap about 1". Pull gently
towards you to remove cap.
8
5-7
5. Remove the roller frame from
the handle or extension handle.
6. Remove roller frame by
unscrewing nut on end of roller
frame.
7. Depress the PUSH TO REMOVE
tab and it will snap to release
the outer end cap.
11
11. Remove spacer from roller
cover.
15
15. Clean the roller frame by
running warm (NOT hot) water
through the roller frame until
clean.
ENGLISH
5/12/10 1:37 PM