Application; Purpose; Scope Of Delivery: Swisto3 - Iontophoresis Set; Special Accessories - KaWe SwiSto3 Mode D'emploi

Dear Customer, thank you for choosing a KaWe product. Our products
are known for their high quality and longevity. This KaWe product
fulfils the requirements of EG Directive 93/42/EWG (standard for me-
dical products). We assume no liability for improper or inadequate use
of this device, or if the device is not checked before use. Please read
these instructions carefully and completely before use and follow the
maintenance instructions.

1. Application

The SwiSto3 is used in medical facilities and in the home by healthcare
professionals as well as by non-professionals.

2. Purpose

The SwiSto3 iontophoresis set is designed to treat intense foot, hand
and underarm perspiration. This is a proven and tested anti-perspira-
tion system that uses tap water iontophoresis. A reduction of perspira-
tion can be observed after as few as approx. 15 - 20 treatments,
lasting 20 to 30 minutes each.
Table of Contents
1. Application ..............................................................................17
2. Purpose ...................................................................................17
3. Scope of delivery: SwiSto3 - iontophoresis set ....................17
4. Special accessories ..................................................................17
5. Manufacturer responsibility ....................................................17
6. Graphical symbols and warnings ...........................................17
7. Contraindications / side effects
and preventative measures ....................................................18
8. Start-up / preparation ............................................................19
9. Treatment of foot or hand perspiration ..................................19
10. Treatment of underarm perspiration ......................................20
11. Important information ...........................................................21
12. Troubleshooting ......................................................................21
12.1 Treatment does not start - possible causes ..........................21
12.2 Treatment is interrupted - possible causes ...........................21
12.3 Treatment current feels too weak - possible causes .............21
12.4 Display does not illuminate - possible causes ......................21
13. Recurring safety inspections pursuant
to § 6 MP regulations for SwiSto3 devices ............................21
14. Cleaning and disinfection ......................................................22
15. Storage while not in use .........................................................22
16. Transport and storage .............................................................22
17. Disposal ...................................................................................22
18. Technical information .............................................................23
19. Guarantee ................................................................................23
20. Guidance and manufacturer's declaration -
electromagnetic immunity .....................................................23
21. Recommended separation distances between portable and
mobile RF communications equipment and the SwiSto3 .....26
3. Scope of delivery: SwiSto3 iontophoresis set
1 x SwiSto3 iontophoresis device
2 x water trays
2 x plate electrodes (150 x 220 mm) incl. cable
2 x electrode sponge pads
1 x charging plug

4. Special accessories

2 x plate electrodes with sponge pockets for underarm perspiration
treatment, 2 x replacement sponge pockets (ca. 90 x 110 mm) alone

5. Manufacturer responsibility

The manufacturer only assumes responsibility for the safety, reliability
and efficient operation of the SwiSto3 iontophoresis device if:
1. repairs, modifications, readjustments or enhancements are per-
formed by the manufacturer or by a person authorised by the manu-
facturer and 2. the electrical system installed in the treatment room
meets the requirements of ICE-stipulations and 3. the SwiSto3
iontophoresis device is used in accordance with the instructions given
Page in the User's Manual.
No liability will be assumed for damages resulting from improper use.
Only use the plate electrodes and connection cables supplied by KaWe
and/or the original KaWe-brand spare parts and accessories.
6. Symbol key:
Power button
Anode
Cathode
Increase current
Decrease current
Menu button for selecting settings
Continuous current
Pulsed current
Treatment time
Battery symbol
Electromagnetic field warning
Charge symbol
BF-type device according to
DIN IEC 601 Part 1/ VDE 0750 Part 1
Heed the User's Manual
Caution!
17