Setting The Volume; Selecting The Chime; Troubleshooting - SilverCrest 113326-14-01 Instructions D'utilisation Et Consignes De Sécurité

Setting the volume

Press the volume button
are a total of 5 possible volume settings: very loud, loud, medium,
soft, very soft.

Selecting the chime

Note: The doorbell has 36 different chimes.
Press the melody selection button
Press the melody selection button
audible signal.
Repeat this process until you have selected your desired audible signal.
The last-selected audible signal is automatically stored.

Troubleshooting

After the influence of extraordinary environmental conditions (e.g. a strong
electromagnetical field) the function of the item may be affected. In this
case, please take off the batteries of both appliances for approximately
2 minutes. Then proceed again as described in the section "Synchronising
the transmitter / receiver".
Electrostatic discharges may lead to malfunctions. If such malfunctions
do occur, remove the battery for a short time and then replace it again.
14 GB/IE
until the desired volume is reached. There
3
. The first audible signal sounds.
4
again to move on to the next
4