Hama Big Zapper Mode D'emploi page 6

• Press desired device mode key (e.g. SAT).
• Release "VOL-" (the indicator is ashing twice if the setting
is deactivated).
6.3 Macro Power
Macro Power enables you to turn two TV/STB devices on/off
simultaneously.
To activate the macro power setting:
• Press desired device mode key (e.g. TV).
• Press and hold "POWER" key.
• Press desired device mode key (e.g. SAT).
• Release "POWER" (the indicator ashes once if the setting
is activated).
To deactivate the macro power setting:
• Press desired device mode key (e.g. TV).
• Press and hold "POWER" key.
• Press desired device mode key (e.g. SAT).
• Release "POWER" (the indicator is ashing twice if the
setting is deactivated).
7. Learn Mode
This remote control is equipped with a learning function.
Thus, you could learn functions of your original remote to this
remote control.
7.1 Before Starting Learn Mode
• The batteries in the two remote controls have to be in good
condition. Replace them if necessary.
• Place the remote controls with the infrared diodes so that
they point towards each other.
• Where necessary adjust the height of both remotes so that
infrared diodes are properly aligned.
• The distance between the remote controls should be
about 3 cm.
BIG ZAPPER
ORIGINAL
ca. 3 cm
Note
• Do not move the remote controls during the learning
procedure.
• Ensure that the room is not lit by uorescents tubes or
low energy consumption lamps since such light sources
could interfere with the copying.
• The 2 remote controls must be at least 1 meter away
from any light source.
• During learning mode, if no key is selected for more than
30 seconds, the learning mode will exit automatically or
if no other remote signal is received.
• Each function key will hold only one command. A new
command to be learned will automatically replace the
previous one.
• It is not possible to learn any new functions to the TV,
STB and Setup key.
7.2 Enter Learn Mode
1. Press and hold the [MUTE] and [VOL+] keys for approx.
3 seconds until the LED will be lit.
2. Enter the code [9] [8] [0], the LED will ash
2 times and then remain on.
3. The Universal Remote Control is now ready to learn
new commands.
7.3 Learning Of Keys
1. Press and release the desired key on the original remo-
te control which you want the command to be learned.
The LED at your Universal Remote Control will ash to
con rm that the information has been received.
2. Then press and release the target key on the Universal
Remote Control you want learned.
3. If the LED ashes 3 times and then remain on, the
command has been learned successfully.
4. Repeat these steps to learn other key functions.
5. Please press the [SETUP] key to save the code and exit
learning mode.
Note
While replacing the batteries, the remote control will keep
the functions of the learned keys.
5