Hama Big Zapper Mode D'emploi page 5

5.3 Auto Code Search
Auto Code Search uses the same preloaded codes as the
Manual Code Search (5.2) but your Universal Remote Control
scanns through the codes automatically until the device
you want to control shows a reaction. This might be that
the device you want to control switches off (POWER key) or
changes the channel (CH+/CH- keys).
5.3.1 Turn on the device you want to control
5.3.2 Press the SETUP key until the LED indicator is
permanently lit.
5.3.3 Select the device you want to control using the device
key (e.g. TV). A successful selection is indicated by the
LED with one ash followed by permanent light.
5.3.4 Press the CH+/CH- keys or POWER to start the Auto
Code Search. The LED indicator ashes once followed
by permanent light. The Universal Remote Control has
a latency of 6 seconds before the rst scan starts.
Note – Scan Speed Settings
Scan Speed Settings can be set at either 1 or 3 seconds.
The default setting for the scan time per single code is 1
sec. If this feels uncomfortable , you can switch to 3 sec.
scan time per single code. To switch between the scan
times, press CH+ or CH- during the
6 sec. latency before Auto Code Search starts scanning.
5.3.5 The LED indicator con rms each single code scan with
a single ash.
5.3.6 Press MUTE to save the code and exit the code search.
The LED indicator turns off.
5.3.7 To stop the Auto Code Search during the scan process,
press the EXIT key.
Note
When all codes are searched without success, the Universal
Remote Control exits Auto Code Search and returns to
operational mode automatically. Currently stored code is
not changed.
5.4 Code Identification
The Code identi cation offers you the possibility, to determine
an already entered code.
5.4.1 Press the SETUP key until the LED indicator is
permanently lit.
5.4.2 Select the device you want to control using the device
key (e.g. TV). A successful selection is indicated by the
LED with one ash followed by permanent light.
4
5.4.3 Press SETUP key. The LED indicator ashes once
followed by permanent light.
5.4.4 To nd the rst digit, press the numeric keys from 0 to
9. The LED indicator ashes once to indicate the rst
digit of the 4-digit code number.
5.4.5 Repeat step 5.4.4 for the second, third and fourth
digit.
TV
6. Special Functions
6.1 Punch Through Channel
The Punch Through Channel allows the CH+ or CH-
commands to bypass the currently controlled device and
switch the channels on a second device.All other commands
remain unin uenced.
To activate the punch through channel setting:
• Press desired device mode key (e.g. TV).
• Press and hold "CH+" key.
• Press desired device mode key (e.g. SAT).
• Release "CH+" (the indicator ashes once if the setting
is activated).
To deactivate the punch through channel setting:
• Press desired device mode key (e.g. TV).
• Press and hold "CH-" key.
• Press desired device mode key (e.g. SAT).
• Release "CH-" (the indicator is ashing twice if the setting
is deactivated).
6.2 Punch Through Volume
The Punch Through Volume allows the VOL+ or VOL-
commands to bypass the currently controlled device and
adjust the volume on a second device. All other commands
remain unin uenced.
To activate the punch through volume setting:
• Press desired device mode key (e.g. TV).
• Press and hold "VOL+" key.
• Press desired device mode key (e.g. SAT).
• Release "VOL+" (the indicator ashes once if the setting
is activated).
To deactivate the punch through volume setting:
• Press desired device mode key (e.g. TV).
• Press and hold "VOL-" key.
CODES
SAT