Hama Big Zapper Mode D'emploi page 4

4. Getting started – installing the Batteries
Note
• Alkaline batteries are recommended.
Use 2 „AA" (LR 6/Mignon) type batteries.
• Remove the battery compartment lid on the back of
your URC (A).
• Check the required battery polarity and insert batteries
according to the "+/–" marks inside the compartment
(B).
• Close battery compartment lid (C).
Note – Code saver
This remote control saves the settings during battery change.
Note – Battery saving function
The remote control switches off automatically when a
button is pressed down for more than 15 seconds. This
conserves battery power if the remote control gets stuck in
a position where the buttons are continually pressed down,
such as between sofa cushions.
5. Setup
Note
• To obtain a proper infrared (IR) transmission, allways
point your Remote control in the approximate direction
of the device you want to control.
• No entry for approx. 30 seconds will time out the Setup
mode. The LED indicator shows six ashes and turns off.
• If you want to control a device , it´s not possible while
the Universal Remote Control is in the Setup Mode.
Exit the Setup mode and select the device you want to
control using the device selection keys.
5.1 Direct Code Entry
Your Universal Remote Control Package contains a code list. The
code list shows 4-digit codes for most TV/STB manufacturers in
alphabetical order. If the device you want to control is covered
by the code list, the Direct Code Entry is the most convenient
entry method.
5.1.1 Turn on the device you want to control
5.1.2 Press the SETUP key until the LED indicator is
permanently lit.
5.1.3 Select the device you want to control using the device
key (e.g. TV). A successful selection is indicated by the
LED with one ash followed by permanent light.
5.1.4 Check code list for brand and type of the device you
want to control.
5.1.5 Enter the corresponding 4-digit code using the 0 – 9
keys. The LED indicator con rms each entered digit via
a short ash and turns off after the fourth digit.
Note
• If the code is valid, it is saved automatically.
• If code is invalid, the LED indicator ashes six times
and then turns off. Repeat steps 5.1.1 to 5.1.5 or use a
different code entry method.
5.2 Manual code search
Your Universal Remote Control is equipped with an internal
memory, which is preloaded with up to
350 codes per device type for the most common
TV/STB devices. You can zap through these codes until the
device you want to control shows a reaction. This might be
that the device you want to control switches off (POWER key)
or changes the channel (CH+/CH- keys).
5.2.1 Turn on the device you want to control
5.2.2 Press the SETUP key until the LED indicator
is permanently lit.
5.2.3 Select the device you want to control using the device
key (e.g. TV). A successful selection is indicated by the
LED with one ash followed by permanent light.
5.2.4 Press the "POWER" or the CH+/CH- key to zap
through the preloaded codes until the device you want
to control reacts.
5.2.5 Press MUTE to save the code and exit the code search.
The LED indicator turns off.
Note
Internal memory limitations allow only up to 350 most
common device codes to be preloaded. Due to the
extensive number of different available TV/STB devices on
the market, it may be possible that only the most common
main functions are available. If so, repeat steps 5.2.1 to
5.2.5 to nd a more compatible code. No code may be
available for some special device models.
3