Checking Oil Level - NORDFOREST 46-113 Mode D'emploi

46-113, 46-114 | 11.2018
Environmental pollution due to used oil!
Leaked or spilled oil is harmful to the environment!
›
Make sure that all used oil is collected when performing an oil
change.
›
Always dispose of used oil correctly and take it to a controlled
disposal point.
The oil tank is filled with hydraulic oil in the factory.
i

Checking oil level

The oil dipstick is located at the filling screw.
Fig. 9: Filling screw with dipstick
›
Unscrew the dipstick and wipe it clean.
›
Insert the dipstick again fully, then draw it out and read off the oil
level:
• If the oil lies between the two markings, the oil level is OK.
• If the oil level lies below the bottom marking, you must top up
the oil with the help of a clean funnel.
• If the oil level lies above the top marking, you must drain off a
little oil.
›
Screw the filling screw on tight again.
ATTENTION
Cleaning and maintenance
8 t wood splitter 59