Fitting Actuation Arm; Electrical Connection; Nordforest 8 T Wood Splitter, 230 V; Nordforest 8 T Wood Splitter - NORDFOREST 46-113 Mode D'emploi

Assembly
Fig. 3: Axis of rotation
of the actuation arm
Fig. 4: Split pin
50 8 t wood splitter

Fitting actuation arm

Before first commissioning of the wood splitter, fasten the actuation
arms.
›
Guide the tube of the actuation arm into the elongated hole in the
actuation rocker. When doing so, the protective plates must face
inwards.
›
Guide the pins supplied through the bracket plate of the wood
splitter and the actuation arm, such that the pin forms the axis of
rotation.
›
Secure the pin with the split pin provided. To do so, insert the split
pin in the hole in the pin and bend the split pin to prevent it falling
out again.

Electrical connection

Nordforest 8 t wood splitter, 230 V

The Nordforest 8 t wood splitter has a 230
cable cross section must be at least 2.5 mm² (cable designation 3x 2.5).
›
Connect the mains power cable to the switch/connector
combination.

Nordforest 8 t wood splitter

Danger due to incorrect rotational direction of the motor!
The hydraulic pump may be damaged.
›
Before commissioning, check the direction of rotation of the
motor.
-
V power connection. The
WARNING
46-113, 46-114 | 11.2018