ZUMEX Minex Manuel De L'utilisateur page 15

DETECTION OF FAILURES
FAILURE POSSIBLE CAUSE
THE MACHINE DOES NOT Machine unplugged
WORK
No power supplied to socket
Switch not activated
Fuse blown
Cover not in proper position.
Information on display SEG 00010
Juice container not in proper
position. Information on display
SEG 00001
Peel container not in proper
position. Information on display
SEG 00010
Safety sensors dirty
THE MACHINE OFTEN Not enough voltage (Alarm 01)
BECOMES BLOCKED WHEN
EXTRACTING JUICE
THE DRUMS ARE NOT Internal failure
SYNCHRONISED
THE EXTRACTORS BREAK Extractors not in right position
CORRECTION
Plug into mains
Check the socket
Activate the switch
Replace fuse in the connection
base (Fig. 2)
Check it is in the right position
Check it is in the right position
Check it is in the right position
Clean the button cover
Check that the voltage is within the
limits indicated in the manual
Notify the Technical Service
Put them in position in accordance
with the manual (Fig. 10)
FAILURE POSSIBLE CAUSE
THE MOTOR CAN BE HEARD Internal failure
BUT THE DRUMS DO NOT
TURN
THE TIPPING BLADE DOES Incorrect position
NOT TIP
Jammed oranges
Internal failure (Alarm 03)
THE TAP BECOMES BLOCKED Excessive seeds or pulp
Silicone seal misplaced
THE DISPENSER DOES NOT Jammed oranges
DISPENSE PROPERLY
THE JUICE COMES OUT The juice contains pips or too
SLOWLY much pulp
Mobile part of tap stuck or blocked
WARNING: All actions taken to unblock the machine will be carried out when the machine
is not plugged into the mains. If after making the checks mentioned here, the machine still
does not work, call the Technical Service.
CORRECTION
Notify the Technical Service
Check it is in the right position
Eliminate the blockage
Notify the Technical Service
Remove and clean tap
Reposition the silicone seal and try
Eliminate blockage. Use the
correct gauge (Fig. 13)
Dismantle and clean the tap, as
shown in Fig. A and/or Fig. B
Dismantle the tap as indicated in
the clearing section of this manual
27