Zanussi THE7050 Notice D'utilisation page 54

• Bac plein (Tank)
laundry
• Filtre (Filter)
• Condenseur (Condenser)
standard dry laundry
BEFORE FIRST USE
Before you use the appliance for the first time do
these operations:
• Clean the tumble dryer drum with a moist cloth.
• Start a short programme (e.g. 30 minutes) with
moist laundry.
DAILY USE
START A PROGRAMME WITHOUT DELAY
START
1. Prepare the laundry and load the appliance.
CAUTION! Make sure that when
you close the door, the laundry
does not catch between the
appliance door and the rubber
seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options for the
type of load.
4. Press the Départ/Pause (Start/Pause)
touchpad.
The programme starts.
STARTING THE PROGRAMME WITH DELAY
START
1. Set the correct programme and options for the
type of load.
2. Press the delay start button again and again as
necessary.
You can delay the start of a
programme by 3, 6 or 9 hours.
3. Press the Départ/Pause (Start/Pause) button.
The LEDs (9H, 6H, 3H) change on each 3 hours.
CHANGE A PROGRAMME
1. Press the on/off button to deactivate appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
54
- the maximum dry
- the more dry laundry
- the
4. Press the button (E) again and again until the
indicator of the correct level comes on.
5. To confirm the adjustment, press and hold
buttons (B) and (D) at the same time for
approximately 2 seconds.
At the beginning of drying cycle (3-5
min.) there could be a slightly higher
sound level. It is because of start of
the compressor that is normal for
compressor powered appliances such:
refrigerators, freezers.
AT THE END OF THE PROGRAMME
When the programme is completed:
• An intermittent acoustic signal operates.
• The indicators Filtre (Filter) and Bac plein (Tank)
comes on.
• The Départ/Pause (Start/Pause) indicator is on.
The appliance continues to operate with the crease
guard phase for approximately other 30 minutes.
The crease guard phase removes creases from
your laundry.
You can remove the laundry before the crease
guard phase is completed. We recommend, for
better results, that you remove the laundry when the
phase is almost completed or completed.
When the crease guard phase is completed:
• The indicators Filtre (Filter) and Bac plein (Tank)
comes on.
• Départ/Pause (Start/Pause) indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and empty the
water container when a programme is
completed.
STAND-BY FUNCTION
To decrease the energy consumption, this function
automatically deactivates the appliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the programme.