High Pass Filter (High Pass); Loudness Adjustment (Loudn E Ss) - Pioneer PRIEMIER SUPER TUNER III DEH-P920R Mode D'emploi

Audio Adjustment
2. Increase or decrease the output
level with the 5/∞ buttons.
The display shows "0" – "–15".
Note:
• You can select the Non-Fading Output setting mode only when Non-Fading output is switched ON
in the Non-Fading Output ON/OFF mode.

High Pass Filter (High Pass)

When you do not want sound in the Subwoofer output frequency range output from the
front or rear speakers, switch the High Pass Filter ON. Only higher frequencies than those
in the selected range are output from the front and rear speakers.
1. Select the High Pass Filter Function mode (High Pass) in the Audio Menu 2.
(Refer to page 48.)
2. Switch the High Pass Filter
Function ON/OFF with the
5/∞ buttons.
3. Select the desired frequency
with the 2/3 buttons.
50 + = 80 + = 125 (Hz)
Loudness Adjustment (Loudn
The Loudness function compensates for deficiencies in the low and high sound ranges at
low volume. You can select a desired Loudness level.
1. Select the Loudness mode (Loudn
(Refer to page 48.)
2. Switch the Loudness function
ON/OFF with the 5/∞ buttons.
3. Select the desired level with the
2/3 buttons.
Low + = Mid + = High
51
ss)
E
ss) in the Audio Menu 2.
E