Publicité
Les langues disponibles
Les langues disponibles
• Repeatedly press the MODE button (14) until the time zone
symbol is displayed.
• Press and hold the MODE button (14) for approx. 3 seconds to
set the required time zone difference.
• To select individual values, press the
button (13) and confirm each selection by pressing the MODE
button (14).
• If you do not make an entry for 2 minutes, you automatically exit
the setup mode.
Alarm clock
• Repeatedly press the Alarm button (16) to display the different
alarms.
• The respective alarm symbols and the corresponding alarm time/
time interval and/or OFF are displayed.
• Press and hold the Alarm button (16) for approximately 3
seconds to set the time of the displayed alarm. The hours display
begins to flash.
• Press the
button (11) or the
▲
for the alarm time and confirm your selection by pressing the
Alarm button (16). The minutes display begins to flash.
• Repeat the process to set the minutes for the alarm time.
• Press the Alarm button (16) again to set the other alarm mode
as well or to return to the time display (10).
• If you do not make an entry for 2 minutes, you automatically exit
the setup mode.
N ote – Alarm
• When activated, the weekday alarm only triggers an alarm on
weekdays (Monday to Friday). The alarm symbol is displayed if
this alarm is activated.
• When activated, the once-only alarm only triggers an alarm
once. The alarm symbol is displayed if this alarm is activated.
This alarm is automatically deactivated after the alarm has
sounded.
• Frost warning with an early alarm signal – this activates if
the outdoor temperature falls below 2° C. The alarm signal
(PRE/AL) begins to blink. You can set this function to activate
15, 30, 45, 60 or 90 minutes before the weekdays or one-off
alarm signal.
• In the corresponding display, press the
button (13) to activate/deactivate the corresponding alarm. The
alarm symbol appears or disappears accordingly.
• When the alarm is triggered, the alarm symbol begins to flash
and an alarm sounds.
• Press the ALARM button (16) to stop the alarm. Otherwise, it
will stop automatically after 2 minutes.
• To return to the time display, press the MODE button (14) again.
6.4. Weather
Weather forecast
• Based on changes in the atmospheric pressure and the data
saved, the base station is able to make weather forecasts for the
next 12 to 24 hours.
button (11) or the
▲
▼
button (13) to select the hour
▼
button (11) or
N ote – Weather forecast
• The weather forecast function is not available during the
first few hours of operation because it requires data that is
collected during operation.
• The probability of an accurate weather forecast is around
70%. This forecast quality applies within around 20 to 30 km
of the location.
• If you take the weather station with you when travelling, a
reliable weather forecast will only be available after 24 hours
because the weather station initially has to determine the local
weather conditions.
• The weather forecast and the current weather are indicated by
various symbols (2):
Symbol (2)
Note
• At night, the sun forecast means a cloudless sky. The weather
station does not detect fog because fog can occur under
various weather conditions.
• The weather station indicates a trend for how the values for air
pressure (1) are likely to develop over the next few hours.
• The weather station also provides a forecast value for the
trend in relation to temperature and humidity calculated on
the relevant outdoor device. These three available trends are
displayed as foll
Display
ows:
TREND
TREND
Weather
Sun
Slightly cloudy
Cloudy
Rain
Snow
Trend
Increasing
Constant
5
Publicité
