Publicité
IV - FASTENING
Screws without adhesive drive lock or re-use after removing used LOCTITE Frein filet SR 242.
Product characteristics
- Colour : pale blue
!
- Temperature : resistance - 55°C to + 150°C
- TO BE USED WITH CARE : avoid any contact with eyes and skin and do not smoke.
Disassembly
- Disassemble the units, in case of lock, heat the screws.
- Clean excess material off the surface and degrease.
Assembly
- Clean and carefully degrease surfaces (the lubricant prevents polymerisation therefore making the product
ineffective) using a solvent or by washing the parts.
- Let evaporate.
- Apply on the thread, if possible at the end of the screw, only one drop of the Loctite frein filet.
- To reduce polymerisation time, spray T activator on the thread,let evaporate and then apply Loctite frein filet.
- Assemble the parts and tighten to the required torque.
- All screws must be tightened as soon after assembly as possible.
- Immediate starting.
Tightening torque
The tightening torques indicated in this manual must be respected.
A tightening torque weaker than indicated may lead to a shearing stress and may break the bolt.
A stonger tightening torque may lead to a plastic deflection of the bolt and damage of the parts.
R013R-08/07
Section 1
Preliminary
-
9 -
Publicité
