EINHELL TH-SS 405 E Mode D'emploi D'origine page 18

Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
5. Before starting the equipment
5.1 General information
•
All covers and safety devices have to be pro-
perly fitted before the machine is switched
on.
•
It must be possible for the blade to run freely.
•
When working with wood that has been
processed before, watch out for foreign bo-
dies such as nails or screws etc.
•
Before you actuate the On/Off switch, make
sure that the saw blade is correctly fitted and
that the machine's moving parts run smoothly.
•
Before you connect the machine to the power
supply, make sure the data on the rating plate
is the same as that for your mains.
5.2 Mounting the saw on a workbench (Fig. 2)
1. It is better to mount the saw on a solid wood
workbench rather than on a weak plywood
stand where vibrations and noise are certain
to be a nuisance.
2. The tools and hardware needed to mount the
saw on a work bench are not supplied with
the saw. Be sure to use equipment of at least
the following size:
Anl_TH_SS_405_E_SPK1.indb 18 Anl_TH_SS_405_E_SPK1.indb 18
GB
Item
Hex screws M8
Gaskets Ø 8 mm
Washers Ø 8 mm
Hex nuts M8
3. A sound-absorbing foam rubber mat is not
supplied with the saw. It is strongly
recommended to use such a mat, however, in
order to minimize vibrations and noise.
Description:
Soft foam rubber mat:
Do not overtighten the screws. Leave enough
scope for the foam rubber mat to develop a good
absorbing eff ect.
Mounting the saw on a workbench, see the Figure
(2) List of components in the illustration:
A: Saw body
B: Foam rubber support
C: Worktable
D: Flat gasket
E: Washer
F: Hex nut
G: Blocking nut
H: Hex screw
5.3 Assembly
Caution! Pull out the power plug before carrying
out any maintenance and conversion work on
your fretsaw.
5.3.1 Mounting the saw blade guard and the
sawdust blower facility (Fig. 4/5/6)
•
Put the retention bolt (9) on the radial arm
(19).
•
Slide the saw blade guard (10) onto the reten-
tion bolt (9).
•
Insert the screw (20) through the bore hole of
the retention bolt (9) and the saw blade guard
(10).
•
Use the nut (21) to secure the screw from
falling out.
•
The saw blade guard can be fixed at various
heights with the clamping screw (11).
•
Mount the blow-off device (16) as shown in
Fig. 6.
- 18 -
Quantity
4
4
4
8
405 x 280 x 13 mm
18.12.12 13:10 18.12.12 13:10