Step 2: Setting The Time - Sony CMT-MD1 Mode D'emploi

Step 2: Setting the
time
You must set the time before you use the
timer functions.
The clock is on a 24-hour system for the
European model, and a 12-hour system for
other models.
The European model is used for illustration
purpose.
CURSOR ?
1
8
1 / u
– +
( P p
= +
+
( P p
–
= +
2,4
– +
3
3,5
1
Press CLOCK/TIMER SET while
the power is off.
The clock appears and the hour
indication flashes.
2
Press +/– to set the hour.
0 0 0
3
Press ENTER/YES or CURSOR /.
The minute indication flashes.
1 1 0 0
4
Press +/– to set the minute.
5
Press ENTER/YES.
The clock starts.
If you have made a mistake
Press CURSOR ? or / repeatedly so that
the incorrect item flashes, then set it again.
To change the preset time
You can change the preset time while the
power is on.
1 Press CLOCK/TIMER SET.
2 Press +/– repeatedly until "CLOCK SET ?"
appears.
3 Press ENTER/YES.
4 Repeat steps 2 through 5.
Tips
• The built-in clock shows the time in the display
while the power is off.
• The upper dot flashes for the first half of a minute
(0 to 29 seconds), and the lower dot flashes for the
last half of a minute (30 to 59 seconds).
:
: