Marking Track Numbers - Sony CMT-MD1 Mode D'emploi

Marking track
numbers
The track numbers can be marked as follows:
• Mark the track numbers automatically.
When you record from this system's CD
(digital recording) or during level-synchro
recording, the track numbers are
automatically marked.
• At any point while recording.
You can mark the track numbers while
recording any sources.

Marking track numbers

automatically while
recording
–– Level-Synchro Recording
The "LEVEL-SYNC" is factory set to ON and
the track numbers are automatically marked.
If "LEVEL-SYNC" is not displayed during
recording, turn it on as follows. Track
numbers are automatically marked when the
input signal is under a certain level for more
than two seconds and then exceeds the
previous level.
6
1/u (P p
= 0 ) +
– +
MD p
g
(P p
+
–
6
1
–
( P
= +
( P
= +
3
–
4,5
1
Press REC. The MD stands by for
recording.
2
Press PLAY MODE on the remote
until "PGM" and "SHUFFLE"
disappear.
3
Press EDIT, then press +/– on the
remote repeatedly until
"LevelSync ?" appears.
4
Press ENTER/YES on the remote.
"LevelSync ON ?" appears.
5
Press ENTER/YES on the remote
again.
"LEVEL-SYNC" lights up.
6
Press MD ^.
Recording starts.
To stop recording
Press MD p.
1 / u
2
+
p
MD p
+
p
–
3
+
continued
35