Sony CMT-MD1 Mode D'emploi page 48

Labeling the preset station
(continued)
5
Press ENTER/YES.
The cursor starts flashing.
Cursor
6
Press CHARACTER repeatedly
until the type of character you want
appears.
Each time you press the button, the
display changes as follow:
A (Upper case) n a (Lower case) n 0
(Numbers) n ! (Symbols)* n (Space)**
n A...
* You can use the following symbols.
!"#$%&'()∗+,–./:;<=>?@_`
** To enter a space
Go to the step 8. You cannot label a
blank space for the first letter.
7
Press +/– repeatedly until the
desired character appears.
8
Press CURSOR /.
The character you selected in step 7 stops
flashing and the cursor shifts to the right.
J
Cursor
9
Repeat steps 6 through 8 to
complete the entire title.
If you enter an incorrect character, press
CURSOR ? or / until the character
you want to change flashes, then repeat
steps 6 through 8. To erase a character,
press CANCEL/NO while the character
is flashing.
48
LEVEL SYNC -
DBFB
PRESET
1
LEVEL SYNC -
DBFB
PRESET
1
10
Press ENTER/YES to complete the
labeling procedure.
To cancel labeling
Press EDIT.
To check the titles
Press DISPLAY.
Each time you press the button, the display
changes as follows:
The station name ˜ Frequency
To erase the name
Do steps 1 to 6 and press CANCEL/NO
repeatedly until the label disappears.