The parameter "1" will appear at the top of the display, and the name of the parameter "QSENS INITIALISATION" will
scroll across the bottom.
Press <2> 1x.
The number "1" will appear at the top of the display and "OFF" will appear at the bottom.
Press the <4> key to change "OFF" to "ON".
Press <2> to start the initialisation.
The message "INITIALIZING QSENS" will scroll across the display.
Press <5> when the two lowest nozzles produce a constant spray of water mist. The system is now bled.
The number "1" will appear at the top of the display and "OFF" will appear at the bottom.
Press <5> 3x to exit the configuration menu.
Attention:
Always dry the sunbed after the initialisation procedure.
24
1: ENG L
1: ENG R