Hapro Luxura V10 Série Mode D'emploi page 23

Qsens (optional)
During a tanning session Qsens will gently spray the body with a fine water mist. This results in a wonderful cooling effect. By default Qsens is set
to spray in intervals of 2 minutes.
Water
Qsens uses a special bacteria-free water. Contaminated water may cause a rash or other unpleasant skin disorders. Therefore, never use ordinary tap water but
make sure to order the special Qsens liquid containers from your dealer.
Maintenance
Qsens is virtually maintenance-free, on the condition that pure water is used. Contaminated water may cause blockages in the spray head and other components.
Damages that are the result of the use of non-original parts or ordinary tap water are not covered by the warranty.
Only use original Hapro parts when carrying out maintenance or repair work.
The sunbed contains electrical components that will break down in damp conditions. Make sure not to spill any liquid on the sunbed.
Always switch off the mains voltage before carrying out any maintenance to the sunbed.
The system should be bled before commissioning the system and if any air is present in the conduit. Refer to the section 'Initialisation' in this product description
to find out how to bleed the system.
Residual liquid from the liquid container may be discharged into the regular water drainage system. The liquid container is made of PE and can be recycled.
Initialisation
Make sure to bleed the system before using Qsens for the first time and when the liquid container has been exchanged. Make sure all air and water hoses are
correctly installed and that the supply hose is correctly positioned in the liquid container before the system is bled.
Follow the instructions below to bleed the Qsens system.
Press the following keys successively:
<5> <5> <4> <5> <3>
The main parameter "P1" will appear at the top of the display, and the name of the main parameter "UNIT" will scroll
across the bottom.
Use the <3> and <4> keys to navigate to main parameter "P3". (Press <4> 2x.)
The main parameter "P3" will appear at the top of the display, and the name of the main parameter "QSENS" will scroll
across the bottom.
Press <2> 1x
23