Preparation; Installing The Antenna - Kenwood TK-2402 Mode D'emploi

INSTALLING THE CHANNEL STOPPER
For transceivers with less than 6 channels, insert a Channel
stopper.
1 Set the Channel selector to channel , then pull the Channel
selector knob off the transceiver.
• If the Channel selector is not positioned at channel , the
Channel selector knob may not install correctly and the channel
may be unable to be changed.
2 Insert the channel stopper.
3 Set the arrow of the Channel stopper to the highest channel
number for the transceiver.
• You can set the Channel stopper position for channels 2, 4, 6,
8, 0, 2, and 4.
4 Reinsert the Channel selector knob.

INSTALLING THE ANTENNA

Antenna
2

PREPARATION

Screw the antenna into the connector on
the top of the transceiver by holding the
antenna at its base and turning it clockwise
until secure.
Note: The antenna is neither a handle, a
key ring retainer, nor a speaker/ microphone
attachment point. Using the antenna in these
ways may damage the antenna and degrade
your transceiver's performance.
Channel stopper
Arrow