Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION & SERVICE MANUAL FOR MOWER DECK
CHAPTER 6. INSTALLATION ON THE TH TRACTOR
6-1. Before installation
- Place the tractor on level, hard ground.
- Stop the engine and draw the engine key before mounting or dismounting the drive shaft.
- Shift the transmission range shift lever to the neutral position.
- Make sure that the parking brakes are applied and the PTO lever is in the off position.
6-2. Installation of the bracket and cylinder on the tractor
Fig.6-1
a. Fix BRACKET/FRONT/LH (9) and BRACK-
ET/FRONT/RH (10) to both left and right side
of the chassis by using each 6 pcs of
BOLT/M12X30
WASHER/M12 (26).
b. Fix
BRACKET/MID/LH
BRACKET/MID/RH (12) to both left and right
side of the chassis by using each 8 pcs of
BOLT/M12X30
WASHER/M12 (26).
c. Remove each 4 pcs of the bolt and pin, and fix
BRACKET/CYLINDER (16) by using the
(25)
and
SPRING
(11)
(25)
and
SPRING
removed bolts.
d. Install HOSE (19) to CYLINDER (6). Fix
CYLINDER (6) to BRACKET/CYLINDER (16)
by using PIN/15X88 (17) and RING PIN (15).
and
e. Arrange HOSE (19) to right side of the tractor
and fix it with CYLINDER (6) by using 2 pcs of
BAND (21).
f.
Connect ADAPTER (20) to the control valve of
the tractor. Connect HOSE (19) to ADAPTER
(20).
40
Publicité
Table des Matières
