Miele STB 101 TURBO MINI Mode D'emploi page 48

en (USA)
When using the hand-held Turbo-
brush follow the Important Safety In-
structions in the Operating Manual
of your vacuum cleaner.
Recommended use
(see illustration on page 2)
The hand-held Turbobrush is intended
for vacuuming upholstered furniture,
mattresses, car seats, carpeted stairs,
etc.
The rotation of the roller brush intensi-
fies the pick-up of hairs and lint.
It is important to observe the clea-
ning and care instructions of the ma-
nufacturer of the surface to be va-
cuumed.
Using the hand-held Turbo-
brush
^ Fit the hand-held Turbobrush on the
suction wand or on the handpiece,
depending on what is the most con-
venient for you for the type of vacuu-
ming you will be doing.
^ For best results, pass the hand-held
Turbobrush slowly backwards and
forwards over the surface to be va-
cuumed.
48
Maintenance and care
,
Always turn the vacuum cleaner
off and remove the plug from the
electrical outlet before cleaning or
servicing the hand-held Turbobrush.
Removing threads and hairs
(see illustrations on page 2)
^ With a pair of scissors, cut any thre-
ads or hairs that have become entan-
gled on the roller brush. Then run the
vacuum cleaner to vacuum up the
pieces.
For more obstinate dirt or blockages in-
side the hand-held Turbobrush, the co-
ver can be opened. Any large particles
inside it can then be easily removed.
^ Turn the grip so that the release but-
ton is in the middle of the guide a.
^ Press in the release button b and
pull the grip out as far as possible
from the hand-held Turbobrush c.
^ Lift the upper part of the casing as far
as it will go, and remove any dirt ad-
hering to the inside of the casing and
the roller brush.
^ Close the casing and push the grip
back into position until it clicks into
place over the release button.