Blower; Blower Installation - Videotec HOV Manuel D'instructions

Open the housing as described (6.1 How to open the
housing, page 6).
Fix the support bracket (02) using the screw (01).
Place the power supply (03) on the support bracket.
Secure it all with the screws (04) and the corner fixing
bracket.
05
03
02
Fig. 11
Plug the multipolar female connector into the
corresponding male connector (J7, 6.3 Board
description, page 7).
Fig. 12
10
04
01

7.3 Blower

7.3.1 Blower installation

Not usable in versions with double filter for
air renewal and wiper.
Pay attention to the voltage value used
when the circuit is powered. Depending on
requirements use the correct power supply
kit.
The blower kit should be assembled
according to the instructions to ensure a
correct air circulation inside the housing.
Open the housing as described (6.1 How to open the
housing, page 6).
Fix the blower using the corner bracket and screws.
01
02
Fig. 13
Plug the multipolar female connector into the
corresponding male connector (J8, 6.3 Board
description, page 7).
MNVCHOV32_1511_EN