Dörr DLP-1000 RGB Notice D'utilisation page 10

02 | SAFETY HINTS FOR RECHARGEABLE BATTERIES
Only use high-quality batteries of popular brands. When inserting the battery
please respect the correct polarity (+/-). Please remove battery when device is not
in use for a long period of time. Do not throw the batteries into fire, do not short-
circuit and do not disassemble them. Never charge non-rechargeable batteries –
risk of explosion! Remove leaking batteries from the device immediately. Risk of
battery acid burn! Clean the contacts before inserting fresh batteries. In case of
contact with battery acid, rinse the affected area immediately with water and con-
tact a doctor. Batteries can be dangerous to life if swallowed. Keep batteries away
from small children and pets. Do not dispose of batteries in household waste (see
also capture "Disposal of Batteries/Accumulators").
03 | PRODUCT DESCRIPTION
Continuous LED light kit for photo and video recordings
with exciting color and light effects.
Long-life 3200 K and RGB LEDs
•
Colour temperature adjustable from 2700 - 9999 K
•
Brightness adjustable
•
04 | NOMENCLATURE
1 Barndoors
2 Locking screws
3 Swivel frame
4 Battery slot
4a) Battery contact pins
5 LCD display
6 Menu button
7 HUE/Saturation button
8 CCT button
9 Main switch
(position I = operation with battery/
position II=operation with power adapter)
10 Socket for power adapter
11 Control dial/press button
12 Socket for light stand with spigot
12a) Locking screw
13 Power adapter
13a) Power cable socket
13b) Connection plug
13c) Screw lock
13d) Power cable
Only included in kit Item No. 373483
14 Battery charger
14a) LED charging indicator
14b) Battery contact pins +/-
14c) Battery slot
14d) Socket for power cable
14e) Power cable
15 Li-Ion battery
15a) Battery contacts +/-
05 | FIRST COMMISSIONING
CAUTION
Before connecting or disconnecting cable connections, make sure that the
main switch (9) is on position O = Off.
Insert the connection plug (13b) into the socket (10) at the LED light. Pay attention
to the pins and holes. Screw tight the screw lock (13c). To disconnect the cable
connection, make sure to open the screw lock (13c) first!
Plug the power cable (13d) into the power cable socket (13a) and connect the power
supply to a socket outlet.
Switch on the LED light at the main switch (9):
position II = On (operation with power adapter).
CAUTION
After each use please turn off the LED light (main switch 9 = position O = Off).
06+07 | LED DISPLAY/SETTINGS
Switch on the LED light at the main switch (9):
position II = On (operation with power adapter) or position I = On (operation with
batteries – refer to chapter 08).
06.1 MENU HUE/SATURATION
Here you can set the desired colour, saturation and intensity. Press the HUE but-
ton (7). The LCD display shows the following overview:
Hue : 188°
Sat : 100%
Int : 100%
R:0 G:117
Battery capacity indicator
Hue (colour)
Sat (saturation)
Int (intensity)
R:/G:/B:/W: (values)
06.1.1 Input field Hue = select colour
Turn the control dial (11) to the desired colour.
0 30 60
Red Orange Yellow
Press the HUE button (7) to confirm your selection and to enter the next input field.
10
B:137 W:0
120 180 240 270
Green Cyan Blue Purple Magenta
300