Setting The Dip Switch; Minidiscs (Md Data Discs) - Sony DKR-700 Mode D'emploi

Setting the DIP Switch

Set the DIP switch as required. (Set the SCSI-ID when
using the SCSI interface.)
1 2 3 4 5 6 7 8
O
N
DIP switch
Setting and function of each switch
Switch Function
number
1 SCSI connector
termination
2 Select the timing for
capturing an input
image to memory using
a foot switch connected
to FS1 connector or
FS2 connector.
3 Select the timing for
capturing an input
image to memory using
a foot switch connected
to FS1 connector or
FS2 connector.
4 reserved
5 reserved
6 SCSI-ID
7 SCSI-ID
8 SCSI-ID
Timing settings for image capture
Switch 2 Switch 3 Timing for image capture to
memory
OFF OFF Third field after trigger signal is input.
(Timing 1)
OFF ON Second field after trigger signal is
input. (Timing 2)
ON a) OFF a) First field after trigger signal is input.
(Timing 3)
a) When switch 2 is set to "ON" and switch 3 to "OFF",
then even when the Flash item in the System Setup menu
is set to On, the signal is not output from the FLASH
connector.
b) For more information about the timings 1 to 3, see
"Timing for Capturing an Image Using a Foot Switch"
(page 53(E)).
Setting
To enable internal
SCSI termination, set
to ON.
See table below.
See table below.
Set to OFF.
Set to OFF.
See SCSI-ID Settings
table.
See SCSI-ID Settings
table.
See SCSI-ID Settings
table.
b)
b)
b)
SCSI-ID Settings
SCSI-ID 0 1 2
Switch 6 OFF OFF OFF OFF ON
Switch 7 OFF OFF ON
Switch 8 OFF ON OFF ON

MiniDiscs (MD Data Discs)

The DKR-700/700P uses data MiniDiscs (MMD-140
MD Data Disc or equivalent).
Using MiniDiscs
• Do not open the protective shutter. Touching the disc
surface directly may damage or dirty the surface,
causing errors or making data unreadable.
• Do not expose the discs to direct sunlight, elevated
temperatures, or dusty environments.
• There is no need to clean MiniDiscs.
3 4 5 6 7
ON ON ON
ON OFF OFF ON ON
OFF ON OFF ON
M
Protective
D
shutter
17(E)