Dometic COOLMATIC CRX1065D Instructions De Montage Et De Service page 18

Installing and connecting the refrigerator
7.4 Installing the refrigerator
Proceed as follows to install the refrigerator:
If you wish to drain the condensate through a hose:
Mount the outlet port (see chapter "Mounting the outlet port (optional)" on
page 17)
Undo the transport lock (chapter "Releasing the lock" on page 24).
Open the refrigerator drawer.
Remove the blanking plugs (fig. 6, page 5).
Push the refrigerator into the recess.
Fix the refrigerator in place using suitable screws (fig. 6, page 5).
Press the blanking plugs (fig. 6, page 5) into the openings.
7.5 Connecting the refrigerator to DC voltage
A
NOTICE!
• To avoid voltage drops and loss of performance, keep the
connection cable as short as possible and not be interrupted.
Therefore avoid additional switches, plugs or power strips.
• Disconnect the cooling device and other electric consumers from
the battery before you connect the battery to a quick charging
device. Overvoltage can damage the electronics of the device.
The refrigerator can be operated with a 12 V or a 24 V DC voltage supply.
For safety reasons, the refrigerator is equipped with an electronic system to prevent
the polarity being reversed. This protects the refrigerator against reversed polarity
when connecting to a battery and against short circuiting.
To protect the battery, the refrigerator switches off automatically if the voltage is
insufficient (see table below).
Cut-off voltage
Cut-in voltage
18
12 V
10.4 V
11.7 V
CRX
24 V
22.8 V
24.2 V
EN