Beta 1947G Mode D'emploi page 7

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
OPERATION MANUAL AND INSTRUCTIONS FOR AIR GREASE GUN MANUFACTURED BY:
BETA UTENSILI S.P.A. Via A. Volta 18, 20845, Sovico (MB) ITALY
Original documentation drawn up in ITALIAN.
CAUTION
Store the safety instructions with care and hand them over to the users.
PURPOSE OF USE
The air grease extrusion gun can be used for the following purposes:
• delivering grease by extrusion, using cartridges or bulk grease
• the gun can also be used in open places exposed to water
The air silicone and sealant gun must not be used for the following purposes:
• the gun must not be used in environments containing explosive atmospheres
• the trigger must not be locked with tape, clamps and any other materials or devices
• no products other than grease may be extruded
• the air silicone and sealant gun must not be used for any applications other than stated ones.
WORK AREA SAFETY
Beware of both surfaces that may become slippery due to the use of the machine and the danger
of tripping over the air hose.
While using the pneumatic tool for jobs performed high from the ground, take all necessary
precautions, to eliminate or minimize risk to other workers, following the accidental falling of any
tools (for example, isolation of the work area).
Do not operate the pneumatic tool in environments containing potentially explosive atmospheres,
because sparks may be generated, which can ignite the dust or fumes.
Avoid contact with live equipment, because the pneumatic tool is not insulated, and contact
with live parts can cause electric shocks.
Keep children and bystanders away from your workplace while operating the pneumatic tool.
Distractions from other people can cause you to lose control over the pneumatic tool.
AIR GREASE GUN USE AND CARE
• Do not overload the pneumatic tool. Use the pneumatic tool intended for your work only.
• Always check that the machine is free from defects. Do not use a pneumatic tool that has
a defective On/Off switch. A pneumatic tool that can no longer be stopped or started is dangerous
and must be repaired.
• Disconnect the air supply before making adjustments on the air gun, changing accessories,
or placing the pneumatic tool aside. This safety measure prevents accidental starting
of the pneumatic tool.
• Store idle pneumatic tools out of the reach of children. Do not allow persons unfamiliar with these
instructions to operate the pneumatic tool.
• Maintain the pneumatic tool with care. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the operation of the pneumatic tool. Have
damaged parts repaired before using the pneumatic tool.
IMPORTANT! READ THIS MANUAL THOROUGHLY BEFORE USING
THE PNEUMATIC TOOL. FAILURE TO COMPLY WITH THE SAFETY
STANDARDS AND OPERATING INSTRUCTIONS MAY RESULT
IN SERIOUS INJURY.
EN I
7