JVC KW-R935BTS Manuel D'instructions page 21

BLUETOOTH®
To
While talking on the first incoming call...
Answer another incoming
call and hold the current
call
Reject another incoming
call
While having two active calls...
End current call and
activate held call
Swap between the
current call and held call
Adjust the phone volume * 1
[00] to [35] (Default: [15])
Switch between hands-free
and private talk modes *
3
* 1
This adjustment will not affect the volume of the other sources.
* 2
Press and hold to continuously increase the volume to 15.
* 3
Operations may vary according to the connected Bluetooth device.
Improve the voice quality
While talking on the phone....
1 Press and hold .
2 Turn the volume knob to select an item (see the following table), then press
the knob.
3 2
Repeat step until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
On the faceplate On the remote control
Press or the volume
( Not available )
knob.
Press and hold or
( Not available )
the volume knob.
Press and hold
Press and hold or
the volume knob.
Press .
( Not available )
Turn the volume knob Press
during a call.
Press during a call.
( Not available )
.
MIC GAIN
NR LEVEL
ECHO CANCEL
.
Make the settings for receiving a call
1
Press
2
Turn the volume knob to select an item (see the following
table), then press the knob.
* 2
or
3
Repeat step
during a call.
activated.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER
RING COLOR
BATT/SIGNAL *
* Functionality depends on the type of the phone used.
LEVEL –10 to LEVEL +10 (LEVEL –04): The sensitivity of the
microphone increases as the number increased.
LEVEL –05 to LEVEL +05 (LEVEL 00): Adjust the noise
reduction level until the least noise is being heard during a
phone conversation.
LEVEL –05 to LEVEL +05 (LEVEL 00): Adjust the echo
cancellation delay time until the least echo is being heard
during a phone conversation.
to enter Bluetooth mode.
2
until the desired item is selected or
01 SEC to 30 SEC: The unit answers incoming call
automatically in the selected time (in seconds). ; OFF: Cancels.
COLOR 01 to COLOR 49 (COLOR 08): Selects the light color
for the buttons as notification when there is an incoming call
and during a call. ; OFF: Cancels.
AUTO: Shows the strength of the battery and signal when the
unit detects a Bluetooth device and the Bluetooth device is
connected. ; OFF: Cancels.
Default: XX
.
Default: XX
17
ENGLISH