Display Settings - JVC KW-R910BT Manuel D'instructions

AUDIO SETTINGS
FADER * 3 * 4
R06 — F06 (00): Adjusts the front and rear
speaker output balance.
BALANCE * 3
L06 — R06 (00): Adjusts the left and right
speaker output balance.
VOL ADJUST –05 — +05 (00): Presets the volume
adjustment level of each source (compared
to the FM volume level). Before adjustment,
select the source you want to adjust.
("VOL ADJ FIX" appears if FM is selected.)
AMP GAIN LOW POWER: Limits the maximum volume
level to 30. (Select if the maximum power
of each speaker is less than 50 W to prevent
damaging the speakers.) ; HIGH POWER: The
maximum volume level is 50.
D.T.EXP ON: Creates realistic sound by compensating
(Digital Track the high-frequency components and restoring
Expander) the rise-time of the waveform that are lost in
audio data compression. ; OFF: Cancels.
L/O MODE SUB.W / REAR: Selects whether rear speakers
or a subwoofer are connected to the REAR/SW
line out terminals on the rear panel (through
an external amplifier).
*
3 This adjustment will not affect the subwoofer
output.
* 4 If you are using a two-speaker system, set the
fader level to [00].

DISPLAY SETTINGS

1 Press and hold MENU.
2
Turn the volume knob to make a selection (see the following table), then press the knob.
2
Repeat step until the desired item is selected.
3 Press MENU to exit.
To return to the previous setting item or hierarchy, press G T/P.
DISPLAY
DIMMER Selects the display and button illumination adjusted in the [BRIGHTNESS] setting.
AUTO: Changes between the day and night adjustments when you turn off or on the car headlights. *
ON: Selects the night adjustments. ; OFF: Selects the day adjustments.
BRIGHTNESS Sets the button, display and USB input terminal brightness for day and night separately.
1 DAY / NIGHT: Select day or night.
2 Select a zone for setting. ( Illustration above)
3 Set the brightness level (00 to 31).
(Default: DAY: 31 ; NIGHT: 11)
2
SCROLL * ONCE: Scrolls the display information once. ; AUTO: Repeats scrolling at 5-second intervals. ;
OFF: Cancels.
* 1
The illumination control wire connection is required. ( 21)
*
2
Some characters or symbols will not be shown correctly (or will be blanked).
Default: XX
1
;
ENGLISH | 15