Bluetooth - JVC KW-R910BT Manuel D'instructions

BLUETOOTH®
You can operate Bluetooth devices using this unit.
Connect the microphone
Rear panel
Microphone input jack
Adjust the
microphone angle
Secure using cord clamps (not
supplied) if necessary.
If you turn off the unit during a phone call
conversation, the Bluetooth connection is
disconnected. Continue the conversation using your
mobile phone.
Supported Bluetooth profiles
– Hands-Free Profile (HFP1.5)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP1.3)
– Object Push Profile (OPP)
– Phonebook Access Profile (PBAP)
– Serial Port Profile (SPP)
Pair a Bluetooth device
When connecting a Bluetooth device to the unit for the first time, perform pairing between
the unit and the device. Once the pairing is completed, the Bluetooth device will remain
registered in the unit even if you reset the unit.
• Up to five devices can be registered (paired) in total.
Microphone
• A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at
(supplied)
any time.
• This unit supports Secure Simple Pairing (SSP).
• Some Bluetooth devices may not automatically connect to the unit after pairing. Connect
the device to the unit manually. Refer to the instruction manual of the Bluetooth device for
more information.
1 Press B /SOURCE to turn on the unit.
2 Search and select "JVC UNIT" on the Bluetooth device.
"BT PAIRING" flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number
(PIN) code immediately after searching.
3 Perform (A) or (B) depending on what scrolls on the display.
• For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A) "[Device Name]"
• "XXXXXX" is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkey which appears on the unit and Bluetooth device is the same.
Press the volume knob to confirm the passkey.
Operate the Bluetooth device to confirm the passkey.
(B)
"[Device Name]"
Press the volume knob to start pairing.
• If "PAIRING"
Bluetooth device.
You can change to a desired PIN code before pairing. ( 13)
• If only "PAIRING" appears, operate the Bluetooth device to confirm pairing.
"PAIRING COMPLETED" appears when pairing is completed.
• " " will light up when a Bluetooth mobile phone is connected.
• " " will light up when a Bluetooth audio player is connected.
"XXXXXX" "VOL – YES" "BACK – NO"
"VOL – YES" "BACK – NO"
"PIN 0000" scrolls on the display, enter the PIN code "0000" into the
ENGLISH | 9