AEG ELECTROLUX EHS 8680 X Notice D'utilisation Et Instructions D'installation page 31

Malfunction
The residual heat display does
not indicate anything.
The automatic
function cannot be switched on.
The automatic timer switch-off
function cannot be set.
The automatic timer switch-off
function cannot be switched off.
The timer minute
cannot be set.
The timer minute
cannot be switched off.
The appliance does
respond to control
entries.
The cooking zone was only
switched on for a short time.
The electronics are defective.
There was a power cut.
warm-up The cooking zone still features
residual heat.
The heat setting is set via the
„heat setting selection" sensor
field .
The cooking
selected.
The control panel is locked.
The cooking
selected.
The control panel is locked.
minder The automatic
function of one cooking zone is
set.
The control panel is locked.
minder The control panel is locked.
not The appliance is switched off.
panel
The electronics are defective.
The overheat protection feature
has switched off all cooking
zones and
functions.
Cause
zone is not
zone is not
switch-off
inhibited their
31
Remedy
There is no malfunction if the
cooking zone is cold.
1. Switch off the appliance.
2. Disconnect the appliance
from the mains power
supply (remove fuse).
3. Call the customer care
service.
The existing residual heat is no
longer displayed.
Allow the cooking zone to cool
down.
1. Switch off the cooking zone.
2. Set the heat setting via the
"heat setting selection"
sensor field .
Cooking zone selection
Unlock the control panel.
Cooking zone selection
Unlock the control panel.
Switch off the automatic switch-
off function.
Unlock the control panel.
Unlock the control panel.
Switching on the appliance.
1. Switch off the appliance.
2. Disconnect the appliance
from the mains power
supply (remove fuse).
3. Call the customer care
service.
Allow the cooking zones to cool
down.